Garage Door Spring Replacement Tips

When your garage door spring breaks, you’re likely going to need to replace it, but where do you start? Here are a few tips. First, you must know that most garage door springs fail in their down position, where the most tension is. If you notice that your garage door is failing in its up position, it may just be a rusted spring. This can be hazardous if you’re walking under it.

Arizona Garage Door Guru

Luckily, the replacement isn’t that hard. Although it does require some time, you’ll also need a few safety tools and a helper. Depending on the size of your spring, you could be looking at a full weekend for the task. Fortunately, you can contact your local garage door supplier for help. Regardless of the size of your garage, a broken spring will likely take only a couple of hours to replace.

The most common cause of garage door spring failure is wear and tear. Garage doors are subjected to roughly 10,000 cycles per spring. This means that a spring will last about seven years if used at the same rate every day. You should also consider that garage door springs can break after a certain number of cycles. Sun Devil Garage Door is currently offering a spring repair special for $159. Whether you choose a spring with a long life or a short one, the costs of garage door spring replacement vary greatly.

While garage door springs are relatively inexpensive, you should be aware that the job can be dangerous. The amount of pressure on torsion springs is significant, and you could hurt yourself or even endanger yourself if you try to fix it yourself. A garage door spring replacement service could cost you between two and four hundred dollars, so you should be prepared for that. And remember to write down the specifications for the spring you need.

Leave comment

Your email address will not be published. Required fields are marked with *.